· By DG Roofing
What Attic Ventilation Does for a Calgary Roof
Most people think of a roof as the shingles. The shingles are the part you can see, but the air moving underneath them decides how long they last. In a climate that swings from a chinook thaw to deep cold in the same week, ventilation does a lot of quiet work.
How it is supposed to work
A vented attic takes cool outside air in low, at the soffits under the eaves, and lets it out high, at the ridge or through roof vents near the peak. Air enters cold, picks up heat and moisture on the way up, and leaves. The intake and the exhaust both have to be there. Exhaust vents with blocked soffits underneath them do very little, because there is nothing feeding them.
The goal is an attic that sits close to the outside temperature. A cold, dry attic keeps the roof deck cold and even.
What goes wrong when it does not work
Two problems, and in Calgary they compound.
The first is moisture. A household puts a surprising amount of water into the air through showers, cooking and laundry. That humid air drifts up into the attic through any gap it can find. In a properly vented attic it moves through and leaves. In a sealed or blocked one it hits the cold underside of the roof deck and condenses. You get frost on the nail tips in January, and when a chinook comes through, that frost melts and drips onto the insulation. Homeowners often report it as a roof leak. It is not. It is the attic raining on itself.
The second is uneven heat. A warm attic melts the snow sitting on the roof from underneath, the meltwater runs down to the cold eave and freezes into an ice dam. Ventilation is one of the main defences against dams, and it is the reason two identical houses on the same street can have completely different ice problems.
Over time, heat and trapped moisture also age shingles from below and can soften the sheathing.
How to check yours
- On a cold day, an attic that feels noticeably warm is not venting properly
- Frost on the underside of the sheathing or on the nail points is a clear sign
- Dark staining on the sheathing means moisture has been sitting there for a while
- Insulation pushed into the eaves blocks the intake and is very common after an insulation top-up
- Bathroom fans that end in the attic instead of running to an exterior vent dump moist air exactly where you do not want it
- Ice building at the same section of eave every winter points at the attic below it
Fixing it
Most fixes are straightforward. Baffles at the eaves hold the insulation back so air can get in. Blocked or painted-over soffit vents get opened up. Bathroom fans get ducted properly to the outside. If the exhaust is undersized for the attic, more roof vents or a ridge vent gets added.
The thing to avoid is adding exhaust without checking intake. Powered vents in particular can pull conditioned air out of the house when the intake is inadequate, which makes the heating bill worse and does not solve the moisture problem.
A new roof over a bad attic has the same problems the old one had, so ventilation is worth checking whenever the roof is looked at. We offer free roofing inspections across Calgary and area.